DC-DC Buck Step-down Volt Converter 8v-35v to 5v 8A 40w 4 port USB Power Charger




Price:
$5.25

Free Shipping


Overview and Specifications:

Product Attribute
Accessory Type : Extension Board
Compatible With : MCU, ARM, raspberry PI, Arduino

Product features
1.4 independent special charging management IC, can effectively support a variety of mobile phones for the maximum current charging, charging speed is fast, safe and reliable
2.Charging identification IC is compatible with the full range of apple’s android products, and most phones can achieve the fastest charging speed.
3.Support 4 USB for 2A current charging at the same time, large current charging fast, the total output current can reach 8A.
4.Input is protected by MOS reverse connection, which maximizes conversion efficiency and reduces loss.
5.Output with overvoltage protection, to see the effective protection of the phone.
6.8-35v ultra-wide input voltage, 12V 24V cars can be perfectly supported.
7.Synchronous rectification scheme can effectively reduce heat and improve efficiency, and the efficiency can reach up to 96%.
8.Industry-advanced flat wire large current inductance, large current and small heat, high conversion efficiency.
9.4 high quality SMT capacitors, and then increase the capacity of MLCC capacitor, the output ripple is lower, less interference.
10.High quality double-layer gold-plated USB port, the service life is 2 times of ordinary USB.
11.The default delivery is about 5.2v output voltage.

Module parameters
Input voltage: DC 8-35v
Input current: 5.5a
Output voltage: 5.2v
Output current: total maximum 8A, current adaptive, mobile phone single port charging maximum 2A.
Dynamic response speed: 300us (load flow variation: 5%)
Conversion efficiency: 95% (12V to 5.2v3.5a)
Load adjustment rate: 0.2-0.3% (10%-50% load 12V input)
Ripple & noise: 120 mvp-p (measured by 20MHz bandwidth 12V to 5.2v3a)
Switching frequency: 100KHz
No-load current: 18mA (measured by 12V vehicle 5V)
Mode of connection: IN input OUT input terminal DC block
Fixed mode :M3*1 M2*2
Net weight: about 36 grams
Support equipment:
Mobile phones, digital cameras, tablets, navigators, car recorders and other devices that need USB power. It can charge 4 mobile phones at the same time, and the total current of 4 channels is 8A.
Various input and output modes, support terminal input, DC block input, output support 4*USB output, terminal output 5V.
Appearance size:
54(length)*39(width)*21(height) mm (including USB port)
Pin type:
VIN+ input positive, GND public, OUT+ output positive

Notes
(1) do not overvoltage and overload use, or it will damage the battery and power supply.
(2) the module can only buck voltage but not boost voltage, and cannot supply power to electrical equipment higher than the input voltage.
(3) pay attention to ventilation and heat dissipation when working at high power and full load for a long time, so as to extend the service life of the power supply.
(4) please do not work at full load for a long time. Please leave 20% allowance for continuous work and pay attention to ventilation and heat dissipation