DECT Repeater GSM900/3G2100 Range Extender Booster With Logarithmic Cycle Antenna Ceiling Antenna – US/EU/UK/AU Plug


Free Shipping

Overview and Specifications:

Product Attribute
Model Number : LSWG3B


Power: 0.5W

Noise Figure: 1.5

Equipment Delay: 1MS

Operating Voltage: AC220V/DC12V

Gain: Up 60db, Down 65db

Standing Wave Ratio: 1.5

Stray Radiation: -36

Coverage: 1000 Square Meters


The repeater is well designed and built,
high in quality, stable and reliable in performance.

The shell is made of high-quality
environment-friendly materials and is formed integrally, which has good heat
resistance, high temperature resistance, flame retardancy and durability.

The repeater comes with an indoor ceiling
antenna and an outdoor logarithmic antenna, the signal amplification and
reception efficiency is higher and more stable.

Supported Frequencies: GSM: Up: 980-915MHz,
Down: 935-960 MHz; 3G/WCDMA: Up: 1920-1990MHz, Down: 2110-2180MHz

How To Install:

Outdoor Antenna Installation: Use the
direction and location where the DECT phone receives the strongest signal at or
around the top of the building as the location for installing the outdoor
antenna. Pay attention to lightning protection. The installation height shall
not be higher than the lightning protection network of the building. If it is
higher than the lightning protection network, a lightning rod 1 meter higher
than the outdoor antenna shall be installed and well grounded. After selecting
the appropriate location, fix the outdoor antenna on the wall or bracket.

Amplifier Installation: Select an
appropriate position to install the amplifier indoors (this position should be
close to the power supply and outdoor antenna end, rain-proof, sun-proof and
well ventilated), and fix it on the wall or bracket. The outdoor antenna is
introduced into the’ BTS’ (outdoor) interface, thus completing the connection
between the outdoor antenna and the amplifier.

Indoor Antenna Installation: After
determining the installation position of the indoor antenna, fix the antenna,
and then connect the indoor antenna with the amplifier – One end is connected
to the interface of the indoor antenna, and the other end is connected to the’
mobile’ (indoor) port of the amplifier.